Tile Repair Services Los Lunas NM

Glazed tiles can protect the wall from water through their hard and sealed surfaces. So the work of repairing moldy tile grout is important to prevent any moisture penetration. See below to learn more and to gain access to tile repair services in Los Lunas, NM and for advice and content on tile repair.

Smith & Sons Hardwood
(505) 565-2443
3647 Mooney Ct Se
Los Lunas, NM
 
Ranchero Builders Supply Co
(505) 864-0619
19404 Highway 314
Belen, NM
 
Gaves Tile
(505) 203-7922
10715 Red Robin Rd Sw
Albuquerque, NM
 
Flooring Specialists
(505) 816-6577
7401 Los Volcanes Rd Nw
Albuquerque, NM
 
Prestige Flooring
(505) 452-0954
5702 Broadway Blvd Se
Albuquerque, NM
 
Prestige Flooring
(505) 869-8453
495 Bosque Farms Blvd
Bosque Farms, NM
 
Carpet Warehouse
(505) 864-2108
1306 E River Rd
Belen, NM
 
Ray''S Flooring Design Center
(505) 883-1967
7401 Los Volcanes Rd Nw
Albuquerque, NM
 
Rays Flooring Specialist
(505) 352-0540
7301 Los Volcanes Rd Nw
Albuquerque, NM
 
Designer Flooring
(505) 877-0063
5717 Greer Loop Sw
Albuquerque, NM
 

How to Repair Moldy Tile Grout

Wondering how to repair moldy tile grout? If you do not have any idea when to actually replace your grout, here is a treat for you. When the grout in your bathroom or kitchen is unsightly (i.e. discolored, chipped, blackened and/or cracked) that is a signal for you to replace the grout.
 
You can do this project the easy way and just call your tile restoration specialists, but if you are a do-it-yourself person then it would be easy for you to replace the grout yourself.
 
1: The first step is to scratch off the grout from the moldy areas. Be sure to protect your tiles while scraping, you can do this by covering the tiles with a tape that easily comes off without leaving any sticky stains. If there is not much grout that needs to be replaced, you can remove the grout by using any hard metal to do the scraping (a knife, a screwdriver, or a small pipe). Any tool that can scrape the small cracks can get a smaller job done. However, if you need to do a major grout removal and repair, it is advisable for you to buy a grout saw. Grout saws are available online or you can also find them in your local hardware store. They are very affordable! Read the instructions on how to use the saw properly. After that, you can run it up and down to scrape off the grout lines. Ok grout removed, right? Check!
 
2:  After removing all the grout clean the surface thoroughly and make sure all particle, grout dust and mold or cleaned off entirely. 
 
3: The next step is to mix your grout. To get the right proportions, ask for advice from the hardware store where you purchased the grout or read the instructions on the packaging. Make sure you buy more grout you expect you will need because it is impossible for you to fill up the joints in an accurate manner.
 
4: Apply the grout into the joint lines of the tiles with the proper grout applicator tool. When you are done applying the grout mix into the joint lines, you should leave it to dry...

Click here to read the rest of this article from Remodeleze.com